VACUUM PUMP(for 1KD-FTV) DISASSEMBLY

PROCEDURE


  1. REMOVE CHECK VALVE SUB-ASSEMBLY

    A01XCWC

    1. Mount the pump in a vise.

      Note

      Place aluminum plates on the vise to prevent damage to the pump.

    2. Remove the union bolt, union and 2 gaskets.

    3. A01XGVS

      Remove the check valve and gasket.

  2. REMOVE VACUUM PUMP END COVER

    A01XMG9

    1. Remove the 3 bolts.

    2. A01XCLJ

      Using a 5 mm pin punch and hammer, tap out the 2 straight pins.

    3. Remove the end cover and 2 O-rings.

  3. REMOVE VACUUM PUMP ROTOR SUB-ASSEMBLY

    A01XCUH

    1. Remove the rotor together with the 5 blades.

      Note

      Be careful not to drop the blades.

  4. REMOVE VACUUM PUMP BLADE


    1. Remove the 5 blades from the rotor.

  5. REMOVE VACUUM PUMP GEAR

    A01XCGL

    1. Mount the gear in a vise.

      Note

      Place aluminum plates on the vise to prevent damage to the gear.

    2. Remove the gear lock nut.

    3. Remove the gear and woodruff key.

  6. REMOVE VACUUM PUMP SHAFT

    A01XCGJ

    1. Using snap ring pliers, remove the snap ring.

    2. A01XELU

      Using a plastic-faced hammer, tap out the shaft.

  7. REMOVE VACUUM PUMP BEARING

    A01XIW6

    1. Using a 17 mm socket wrench and press, press out the bearing.