CRAWL SWITCH INSPECTION

PROCEDURE


  1. INSPECT COMBINATION SWITCH ASSEMBLY (CRAWL SWITCH)


    1. B001ILKC01
      *a LO
      *b LO / MEDIUM
      *c MEDIUM
      *d MEDIUM / HI
      *e HI
      B001DVQC17
      *a

      Component without harness connected

      Combination Switch Assembly (Crawl Switch)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      17 (ECU) - 24 (E) LO Below 1 Ω
      18 (UP) - 24 (E)
      19 (DN) - 24 (E) 10 kΩ or higher
      17 (ECU) - 24 (E) LO / MEDIUM Below 1 Ω
      18 (UP) - 24 (E) 10 kΩ or higher
      19 (DN) - 24 (E)
      17 (ECU) - 24 (E) MEDIUM 10 kΩ or higher
      18 (UP) - 24 (E)
      19 (DN) - 24 (E)
      17 (ECU) - 24 (E) MEDIUM / HI 10 kΩ or higher
      18 (UP) - 24 (E)
      19 (DN) - 24 (E) Below 1 Ω
      17 (ECU) - 24 (E) HI 10 kΩ or higher
      18 (UP) - 24 (E) Below 1 Ω
      19 (DN) - 24 (E)
      21 (FRB) - 24 (E) ON/OFF: Pressed Below 1 Ω
      ON/OFF: Not pressed 10 kΩ or higher

      If the result is not as specified, replace the combination switch assembly (crawl switch).

    2. B001DVQC16
      *a

      Component without harness connected

      Combination Switch Assembly (Crawl Switch)

      Apply battery voltage between the terminals of the switch, and check the illumination condition of the combination switch assembly (crawl switch).

      Standard
      Measurement Condition Specified Condition

      Battery positive (+) → 13 (ILL+)

      Battery negative (-) → 12 (ILL-)

      		 Illuminates

      If the result is not as specified, replace the combination switch assembly (crawl switch).