STEERING ANGLE SENSOR INSTALLATION

PROCEDURE

1. INSTALL SPIRAL CABLE WITH STEERING ANGLE SENSOR

   Click here

   Note

   
   

   • Do not replace the spiral cable with the battery connected and the ignition switch ON.

   • Do not rotate the spiral cable with the battery connected and the ignition switch ON.

   • Make sure that the steering wheel is installed and aligned straight when inspecting the steering angle sensor.

   • Do not remove the steering angle sensor from the spiral cable.

2. INSTALL STEERING COLUMN COVER

   
   

   1. for Manual Tilt and Manual Telescopic Steering Column:

      Click here

   2. for Power Tilt and Power Telescopic Steering Column:

      Click here

3. ADJUST SPIRAL CABLE

   Click here

4. INSTALL STEERING WHEEL ASSEMBLY

   Click here

5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

6. CHECK SRS WARNING LIGHT

   Click here