MULTI-TERRAIN SELECT SWITCH INSPECTION

PROCEDURE


  1. INSPECT MULTI-TERRAIN SELECT SWITCH


    1. A01XCSBE02
      B001DVQE14

      Measure the resistance according to the value(s) in the table below.

      Text in Illustration
      *a MUD & SAND
      *b LOOSE ROCK
      *c MOGUL
      *d ROCK & DIRT
      *e ROCK
      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      17 (ECU) - 24 (E) MUD & SAND Below 1 Ω
      18 (UP) - 24 (E)
      19 (DN) - 24 (E) 10 kΩ or higher
      17 (ECU) - 24 (E) LOOSE ROCK Below 1 Ω
      18 (UP) - 24 (E) 10 kΩ or higher
      19 (DN) - 24 (E)
      17 (ECU) - 24 (E) MOGUL 10 kΩ or higher
      18 (UP) - 24 (E)
      19 (DN) - 24 (E)
      17 (ECU) - 24 (E) ROCK & DIRT 10 kΩ or higher
      18 (UP) - 24 (E)
      19 (DN) - 24 (E) Below 1 Ω
      17 (ECU) - 24 (E) ROCK 10 kΩ or higher
      18 (UP) - 24 (E) Below 1 Ω
      19 (DN) - 24 (E)
      20 (FRE) - 24 (E) ON/OFF: Pressed Below 1 Ω
      ON/OFF: Not pressed 10 kΩ or higher
      Text in Illustration
      *a

      Component without harness connected

      (Center Cluster Module Switch (Multi-terrain Select Switch))

      If the result is not as specified, replace the center cluster module switch (multi-terrain select switch).