TRIP SWITCH REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. DISABLE AUTOAWAY/RETURN FUNCTION (for Power Tilt and Power Telescopic Steering Column)


    1. Disable the Autoaway/Return function by changing the customize parameter.

      Click here

      Note

      Record the current customize parameter setting (whether the Autoaway/Return function is enabled or disabled) in order to restore the current setting after finishing the operation.

      Tech Tips

      Performing the above operation causes the Autoaway/Return function to be disabled when the ignition switch is turned off.

    2. Turn the ignition switch to ON. Operate the tilt and telescopic switch to fully extend and lower the steering column.

    3. Turn the ignition switch off.

  2. REMOVE INSTRUMENT CLUSTER FINISH PANEL ORNAMENT (for LHD)

    Click here

  3. REMOVE INSTRUMENT PANEL FINISH PLATE GARNISH (for RHD)

    Click here

  4. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY

    Click here

  5. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

    Click here

  6. REMOVE TRIP SWITCH


    1. B001CWF

      Detach the 2 claws and remove the trip switch.