VEHICLE STABILITY CONTROL SYSTEM(for Vacuum Brake Booster), Diagnostic DTC:C1433

DTC Code DTC Name
C1433 Steering Angle Sensor Internal Circuit

DESCRIPTION

Signals from the steering angle sensor (spiral cable sub-assembly) are sent to the skid control ECU (brake actuator assembly) through CAN communication.

DTC Code DTC Detection Condition Trouble Area
C1433 With the IG1 terminal voltage between 9.5 and 17.4 V, the skid control ECU receives an error signal from the steering angle sensor. Steering angle sensor (Spiral cable sub-assembly)

WIRING DIAGRAM

Refer to DTC C1432 Click here.

CAUTION / NOTICE / HINT

Tech Tips


  • When DTC U0073, U0123, U0124 and/or U0126 is output together with DTC C1433, inspect and repair the trouble areas indicated by DTC U0073, U0123, U0124 and/or U0126 first Click here.

  • When any of the speed sensors or the yaw rate and acceleration sensor (airbag sensor assembly) has trouble, DTCs for the steering angle sensor (spiral cable sub-assembly) may be stored even when the steering angle sensor (spiral cable sub-assembly) is normal. When DTCs for the speed sensors or yaw rate and acceleration sensor (airbag sensor assembly) are output together with DTCs for the steering angle sensor, inspect and repair the speed sensor and yaw rate and acceleration sensor (airbag sensor assembly) first, and then inspect and repair the steering angle sensor (spiral cable sub-assembly).

PROCEDURE


  1. REPLACE SPIRAL CABLE SUB-ASSEMBLY


    1. Replace the steering angle sensor (spiral cable sub-assembly) Click here.

      Note


      • Do not remove the steering angle sensor from the spiral cable sub-assembly.

      • When replacing the steering angle sensor (spiral cable sub-assembly), confirm that the replacement part is of the correct specification.


    NEXT

    END