VEHICLE STABILITY CONTROL SYSTEM(for Vacuum Brake Booster) Slip Indicator Light does not Come ON

DESCRIPTION

Refer to Slip Indicator Light Remains ON Click here

WIRING DIAGRAM

Refer to Slip Indicator Light Remains ON Click here.

CAUTION / NOTICE / HINT

Note


  • Inspect the fuses for circuits related to this system before performing the following inspection procedure.

  • When replacing the brake actuator assembly, perform calibration Click here.

PROCEDURE


  1. CHECK CAN COMMUNICATION SYSTEM


    1. Check if CAN communication system DTCs are output (for LHD without Entry and Start System: See page , for LHD with Entry and Start System: Click here.

      Result
      Result Proceed to
      DTC not output A
      DTC output for LHD without Entry and Start System B
      DTC output for LHD with Entry and Start System C

    B

    GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) Click here

    C

    GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) Click here

    A

  2. READ VALUE USING INTELLIGENT TESTER (SLIP INDICATOR LIGHT)


    1. Turn the ignition switch off.

    2. Connect the intelligent tester to the DLC3.

    3. Turn the ignition switch to ON.

    4. Turn the intelligent tester on.

    5. Enter the following menus: Chassis / ABS/VSC/TRC / Data List.

      ABS/VSC/TRC
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Slip Indicator Light Slip indicator light / ON or OFF OFF -

    6. When performing the Slip Indicator Light Active Test, check Slip Indicator Light in the Data List Click here.

      ABS/VSC/TRC
      Tester Display Test Part Control Range Diagnostic Note
      Slip Indicator Light Slip indicator light Indicator light ON/OFF Observe the combination meter.
      Result
      Result Proceed to
      Data List Display Data List Display when Performing Active Test ON/OFF Operation
      ON Does not change between ON and OFF A
      Changes between ON and OFF B
      OFF Does not change between ON and OFF A
      Changes between ON and OFF B

    A

    REPLACE BRAKE ACTUATOR ASSEMBLY Click here

    B

    GO TO METER / GAUGE SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) Click here