VEHICLE STABILITY CONTROL SYSTEM(for Hydraulic Brake Booster) Slip Indicator Light does not Come ON

DESCRIPTION

Refer to Slip Indicator Light Remains ON Click here.

WIRING DIAGRAM

Refer to Slip Indicator Light Remains ON Click here.

CAUTION / NOTICE / HINT

PROCEDURE

1. READ VALUE USING INTELLIGENT TESTER (SLIP INDICATOR LIGHT)

   
   

   1. Turn the ignition switch off.

   2. Connect the intelligent tester to the DLC3.

   3. Turn the ignition switch to ON.

   4. Turn the intelligent tester on.

   5. Enter the following menus: Chassis / ABS/VSC/TRC / Data List.

      ABS/VSC/TRC

      Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
      Slip Indicator Light	Slip indicator light/ ON or OFF	ON: Indicator light on OFF: Indicator light off	-

   6. When performing the Slip Indicator Light Active Test, check Slip Indicator Light in the Data List Click here.

      ABS/VSC/TRC

      Tester Display	Test Part	Control Range	Diagnostic Note
      Slip Indicator Light	Slip indicator light	Indicator light ON/OFF	Observe the combination meter.

      Result

      Result		Proceed to
      Data List Display	Data List Display when Performing Active Test ON/OFF Operation
      ON	Changes between ON and OFF	A
      	Does not change between ON and OFF (for LHD)	B
      	Does not change between ON and OFF (for RHD)	C
      OFF	Changes between ON and OFF	A
      	Does not change between ON and OFF (for LHD)	B
      	Does not change between ON and OFF (for RHD)	C

   
   

   A

   GO TO METER / GAUGE SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) Click here

   B

   REPLACE MASTER CYLINDER SOLENOID Click here

   C

   REPLACE MASTER CYLINDER SOLENOID Click here