TIRE PRESSURE WARNING RECEIVER(for 3 Door) INSTALLATION

PROCEDURE

1. INSTALL ELECTRICAL KEY & TPMS RECEIVER ASSEMBLY (TIRE PRESSURE WARNING ECU AND RECEIVER)

   
   

   1. Install the tire pressure warning ECU and receiver with the bolt.

      Torque:

      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

   2. Connect the connector.

2. INSTALL REAR QUARTER TRIM PANEL ASSEMBLY LH

   Click here

3. INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH

   Click here

4. INSTALL OUTER LAP BELT ANCHOR COVER

   Click here

5. INSTALL QUARTER TRIM POCKET TRAY

   Click here

6. INSTALL FRONT DECK SIDE TRIM COVER (w/ Tonneau Cover)

   Click here

7. INSTALL NO. 1 TONNEAU COVER HOLDER CAP (w/o Tonneau Cover)

   Click here

8. INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK

   Click here

9. INSTALL REAR FLOOR CARPET ASSEMBLY

   Click here

10. INSTALL QUARTER TRIM COVER HOLE LH

    Click here

11. INSTALL QUARTER TRIM COVER HOLE RH

    Click here

12. INSTALL REAR FLOOR MAT REAR SUPPORT PLATE

    Click here

13. INSTALL MAT SET PLATE COVER

    Click here

14. INSTALL TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)

    Click here

15. INSTALL REAR NO. 1 SEAT ASSEMBLY (w/ Rear No. 1 Seat)

    
    

    1. for LH Side:

       Install the rear No. 1 seat assembly Click here.

    2. for RH Side:

       Install the rear No. 1 seat assembly Click here.

16. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.