| DTC Code | DTC Name |
|---|---|
| C2198 | Initialization Switch Error (for Test Diagnosis) |
DESCRIPTION
During test mode, when the tire pressure warning reset switch is on, the tire pressure warning light comes on and when the tire pressure warning reset switch is off, the tire pressure warning light blinks at 0.125 second intervals.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Note |
|---|---|---|---|---|
| C2198 | Initialization Switch Error (for Test Diagnosis) | Test mode procedure is performed. |
|
- |
WIRING DIAGRAM
| *a | Tire Pressure Warning Reset Switch |
| *b | Tire Pressure Warning ECU and Receiver |
CAUTION / NOTICE / HINT
Note
When replacing the tire pressure warning ECU and receiver, read the transmitter IDs stored in the old ECU using the GTS and write them down before removal.
It is necessary to perform initialization after registration Click here of the transmitter IDs into the tire pressure warning ECU and receiver if the ECU has been replaced.
PROCEDURE
INSPECT TIRE PRESSURE WARNING RESET SWITCH
Turn the ignition switch off.
Remove the tire pressure warning reset switch.
Inspect the tire pressure warning reset switch.
| Result | |||
|---|---|---|---|
|
| NG |
|
REPLACE TIRE PRESSURE WARNING RESET SWITCH Click here |
| OK |
|
CHECK HARNESS AND CONNECTOR (TIRE PRESSURE WARNING RESET SWITCH - TIRE PRESSURE WARNING ECU AND RECEIVER)
Disconnect the G153 tire pressure warning reset switch connector.
Disconnect the R41 tire pressure warning ECU and receiver connector.
Measure the resistance according to the value(s) in the table below.
| Standard Resistance | ||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
| Result | |||
|---|---|---|---|
|
| OK |
|
REPLACE TIRE PRESSURE WARNING ECU AND RECEIVER for 3 door: Click here |
| NG |
|
REPAIR OR REPLACE HARNESS OR CONNECTOR |