REAR STABILIZER BAR(w/o KDSS) INSPECTION

PROCEDURE


  1. INSPECT REAR STABILIZER LINK ASSEMBLY


    1. A01XMG4

      As shown in the illustration, flip the ball joint stud back and forth 5 times.

    2. Using a torque wrench, turn the nut continuously at a rate of 3 to 5 seconds per turn and take a torque reading on the 5th turn.

      Standard turning torque
      0.05 to 1.96 N*m (0.51 to 20 kgf*cm, 0.44 to 17.3 in.*lbf)