REAR STABILIZER BAR(w/ KDSS) INSTALLATION

PROCEDURE


  1. INSTALL REAR STABILIZER LINK ASSEMBLY


    1. Install the rear stabilizer link assembly with the bolt and nut.

      Torque:
      100 N*m  { 1020 kgf*cm, 74 ft.*lbf }

      Tech Tips

      Turn the nut while holding the bolt.

  2. INSTALL REAR STABILIZER CONTROL CYLINDER


    1. Install the 2 bleeder plug caps to the rear stabilizer control cylinder.

    2. Install the rear stabilizer control cylinder with the bolt and nut.

      Torque:
      100 N*m  { 1020 kgf*cm, 74 ft.*lbf }

      Note

      Do not hold the rear stabilizer control cylinder by the cylinder boot.

      Tech Tips

      Turn the nut while holding the bolt.

  3. CONNECT REAR STABILIZER CONTROL TUBE ASSEMBLY


    1. A01XHF6

      Connect the rear stabilizer control tube to the rear stabilizer control cylinder with the 2 union bolts and 2 new pressure port gaskets.

      Torque:
      69 N*m  { 704 kgf*cm, 51 ft.*lbf }

      Note

      Insert the stoppers of the rear stabilizer control tube into the rear stabilizer control cylinder.

  4. TEMPORARILY INSTALL REAR STABILIZER BAR SUB-ASSEMBLY


    1. A01XKEX

      Install the 2 rear stabilizer bushes to the rear stabilizer bar.

      Tech Tips

      Install the stabilizer bush to the outer side of the stabilizer bush stopper on the stabilizer bar.

      Text in Illustration
      B001DEF Outer Side

    2. Temporarily install the rear stabilizer bar with the 2 bolts and nuts.

  5. INSTALL REAR STABILIZER LOWER BRACKET


    1. A01XICZ

      Support the rear stabilizer bar with a jack.

      Note

      Place a wooden block between the jack and rear stabilizer bar to prevent damage.

    2. A01XG1FE01
      Text in Illustration
      *1 Rear Stabilizer Control Cylinder
      *2 Rear Stabilizer Link

      Install the rear stabilizer bar and 2 rear stabilizer lower brackets with the 4 bolts.

      Torque:
      45 N*m  { 459 kgf*cm, 33 ft.*lbf }

      Tech Tips

      Check that the protrusions on the rear stabilizer bush are positioned within 180° of the rear stabilizer control cylinder and rear stabilizer link.

  6. BLEED SUSPENSION FLUID


    1. Bleed the suspension fluid Click here.

  7. STABILIZE SUSPENSION

    Click here

  8. TIGHTEN REAR STABILIZER BAR SUB-ASSEMBLY


    1. Tighten the 2 bolts and 2 nuts.

      Torque:
      110 N*m  { 1122 kgf*cm, 81 ft.*lbf }

      Note

      Turn the bolt while holding the nut.

  9. INSTALL STABILIZER CONTROL VALVE PROTECTOR

    Click here

  10. INSTALL SIDE STEP ASSEMBLY LH (for 5 Door)

    Click here

  11. INSPECT VEHICLE HEIGHT


    1. Inspect the vehicle height Click here.