REAR LOWER ARM INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

  • A bolt without a torque specification is shown in the standard bolt chart Click here.

PROCEDURE


  1. TEMPORARILY INSTALL LOWER CONTROL ARM ASSEMBLY LH


    1. A01XHSJE06
      Text in Illustration
      *a Front
      *b Outer Side

      Temporarily install the lower control arm assembly with the bolt and nut.

      Tech Tips

      Install the lower control arm assembly as shown in the illustration.

    2. Temporarily install the lower control arm assembly to the rear axle housing with the nut and bolt.

  2. CONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY


    1. Connect the No. 3 parking brake cable assembly with the bolt.

      Torque:
      13 N*m  { 127 kgf*cm, 9 ft.*lbf }

  3. INSTALL REAR WHEEL

    Torque:
    for Aluminum Wheel
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }
    for Steel Wheel
    112 N*m  { 1137 kgf*cm, 82 ft.*lbf }

  4. STABILIZE SUSPENSION

    Click here

  5. TIGHTEN LOWER CONTROL ARM ASSEMBLY LH


    1. A01XHNP

      Tighten the 2 bolts.

      Torque:
      130 N*m  { 1326 kgf*cm, 96 ft.*lbf }

      Tech Tips

      While holding the nut, turn the bolt.