REAR COIL SPRING(w/o Air Suspension) INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

  • A bolt without a torque specification is shown in the standard bolt chart Click here.

PROCEDURE


  1. INSTALL HOLLOW SPRING SUB-ASSEMBLY (for 5 Door)


    1. Install the hollow spring to the frame.

  2. INSTALL REAR COIL SPRING LH


    1. A01XHFO

      Install the rear coil spring to the rear axle housing.

      Tech Tips

      Before installing the coil spring, check that the coil spring end is in the correct position. If not, reinstall the coil spring.

  3. TEMPORARILY INSTALL REAR SHOCK ABSORBER ASSEMBLY LH


    1. Temporarily install the lower side of the shock absorber with the bolt.

  4. INSTALL REAR STABILIZER LOWER BRACKET (w/ KDSS)

    Click here

  5. STABILIZE SUSPENSION

    Click here

  6. TIGHTEN REAR SHOCK ABSORBER ASSEMBLY LH


    1. Tighten the bolt.

      Torque:
      98 N*m  { 999 kgf*cm, 72 ft.*lbf }

  7. CONNECT REAR FLEXIBLE HOSE

    Click here

  8. BLEED BRAKE LINE


    1. for Hydraulic Brake Booster:

      Bleed the brake line Click here.

    2. for Vacuum Brake Booster:

      Bleed the brake line Click here.

  9. INSTALL REAR WHEEL

    Torque:
    for Aluminum Wheel
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }
    for Steel Wheel
    112 N*m  { 1137 kgf*cm, 82 ft.*lbf }