HEIGHT CONTROL SWITCH INSPECTION

PROCEDURE


  1. INSPECT CENTER CLUSTER MODULE SWITCH (HEIGHT CONTROL SWITCH)


    1. B001DVQE17
      Text in Illustration
      *a

      Component without harness connected

      (Height Control Switch)

      Measure the resistance according to the values in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      7 (LO) - 24 (E) "Down" pressed Below 1 Ω
      "Up" pressed 10 kΩ or higher
      6 (HI) - 24 (E) "Down" pressed 10 kΩ or higher
      "Up" pressed Below 1 Ω

      If the result is not as specified, replace the center cluster module switch (height control switch).