HEIGHT CONTROL SENSOR REMOVAL

CAUTION / NOTICE / HINT

Note

Before removal, be sure to disable vehicle height control by pressing the height control OFF switch and confirming that the height control OFF indication is displayed on the meter.

PROCEDURE


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note


    • After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  2. REMOVE REAR WHEEL

  3. REMOVE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH


    1. B001F1C

      Disconnect the connector, and then detach the connector.

    2. Detach the clamp.

    3. B001EMNE02
      Text in Illustration
      *1 Matchmark

      Place matchmarks on the link and bracket.

    4. Remove the nut and disconnect the sensor link.

    5. Remove the 2 bolts and height control sensor.

      Note

      Replace the rear height control sensor sub-assembly with a new one if it is dropped.

  4. REMOVE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY RH

    Tech Tips

    Use the same procedure described for the LH side.