HEIGHT CONTROL COMPRESSOR REMOVAL

CAUTION / NOTICE / HINT

PROCEDURE

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

   CAUTION:

   Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

   Note

   
   

   • After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

   • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

2. REMOVE REAR WHEEL LH

3. REMOVE REAR QUARTER PANEL MUDGUARD SUB-ASSEMBLY LH

   Click here

4. REMOVE HEIGHT CONTROL COMPRESSOR COVER

   
   

   1. Remove the 3 clips and height control compressor cover.

5. REMOVE REAR BUMPER PROTECTOR SUB-ASSEMBLY LH (for 5 Door)

   Click here

6. REMOVE HEIGHT CONTROL FILTER

   
   

   1. Slide the 2 clips and disconnect the 2 hoses.

   2. 

      Remove the 2 bolts and height control filter from the height control compressor bracket.

7. DISCONNECT NO. 2 HEIGHT CONTROL TUBE

   
   

   1. 

      Disconnect the No. 2 height control tube from the No. 2 height control valve Click here.

      Tech Tips

      For the disconnection procedure of the tube (type 2), refer to Precaution of the Suspension Control System section.

8. REMOVE HEIGHT CONTROL COMPRESSOR ASSEMBLY

   
   

   1. 

      Disconnect the connector.

   2. Detach the 3 clamps.

   3. Detach the No. 2 height control tube.

   4. 

      Disconnect the connector.

   5. Detach the clamp.

   6. 

      Remove the 3 bolts and height control compressor.

   7. 

      Remove the bolt and height control dryer.

   8. Remove the O-ring.

   9. 

      Remove the 3 bushes from the height control compressor.

9. REMOVE HEIGHT CONTROL COMPRESSOR BRACKET

   
   

   1. 

      Remove the 3 bolts and height control compressor bracket.