REAR AXLE SHAFT REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE REAR WHEEL

  4. DRAIN BRAKE FLUID

  5. DISCONNECT REAR FLEXIBLE HOSE LH

    Click here

  6. REMOVE REAR SPEED SENSOR LH

    Click here

  7. REMOVE PARKING BRAKE ASSEMBLY


    1. Remove the parking brake assembly Click here.

  8. REMOVE REAR AXLE SHAFT WITH PARKING BRAKE PLATE LH


    1. B001DQ9

      Remove the 4 nuts and rear axle shaft with parking brake plate.

    2. Remove the O-ring.

  9. REMOVE REAR AXLE SHAFT OIL SEAL LH

    B001EPW

    1. Using SST, remove the rear axle shaft oil seal.

      SST
      09308-00010