PROPELLER SHAFT ASSEMBLY DISASSEMBLY

PROCEDURE


  1. REMOVE REAR PROPELLER SHAFT UNIVERSAL JOINT SLEEVE YOKE SUB-ASSEMBLY


    1. A01XCN0E10
      Text in Illustration
      *a Matchmark

      Place matchmarks on the propeller shaft and sleeve yoke.

    2. Remove the sleeve yoke from the propeller shaft.

  2. REMOVE REAR PROPELLER SHAFT UNIVERSAL JOINT SPIDER BEARING

    Tech Tips

    Use the same procedure for all rear propeller shaft universal joint spider bearing.


    1. A01XIQ6E18
      Text in Illustration
      *a Matchmark

      Place matchmarks on the flange yoke and sleeve yoke.

    2. A01XDPF

      Using a brass bar and hammer, slightly tap in the spider bearing outer races.

    3. Using 2 screwdrivers, remove the 4 snap rings from the grooves.

    4. A01XCV9E27

      Using SST, remove the spider bearing from the sleeve yoke.

      SST
      09332-25010

      Tech Tips

      Before installing SST, sufficiently raise the part labeled A. If the part labeled A is too low, it may be difficult to install SST.

    5. A01XGQHE19
      Text in Illustration
      *a Hammering Point

      Clamp the spider bearing outer race in a vise and tap off the propeller shaft with a hammer.

      Tech Tips

      Remove the spider bearing on the opposite side using the same procedure.

      Note

      Do not tap the shaft.

    6. A01XDJ6E23

      Install the 2 removed spider bearing outer races to the universal joint spider.

    7. Using SST, remove the bearing from the yoke.

      SST
      09332-25010

      Tech Tips

      Sufficiently raise the part labeled by A so that it does not come into contact with the bearing.

    8. A01XGH5E18
      Text in Illustration
      *a Hammering Point

      Clamp the outer bearing race in a vise between aluminum plates and tap off the yoke with a hammer.

    9. Remove the universal joint spider.