4WD CONTROL ECU INSTALLATION

PROCEDURE

1. INSTALL 4 WHEEL DRIVE CONTROL ECU

   
   

   1. Install the 4 wheel drive control ECU with the bolt.

      Torque:

      13 N*m  { 127 kgf*cm, 9 ft.*lbf }

   2. Connect the 2 connectors.

2. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY

   Click here

3. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

   Click here

4. INSTALL INSTRUMENT PANEL ORNAMENT

   Click here

5. INSTALL INSTRUMENT SIDE PANEL RH

   Click here

6. INSTALL COWL SIDE TRIM BOARD RH

   Click here

7. INSTALL DOOR SCUFF PLATE ASSEMBLY RH

   Click here

8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.