FRONT AXLE HUB ON-VEHICLE INSPECTION

PROCEDURE


  1. REMOVE FRONT WHEEL

  2. REMOVE FRONT DISC BRAKE CYLINDER ASSEMBLY LH

    Click here

  3. REMOVE FRONT DISC

    Click here

  4. REMOVE FRONT AXLE HUB GREASE CAP

    Click here

  5. INSPECT FRONT AXLE HUB BEARING LOOSENESS


    1. A01XCZ7

      Using a dial indicator, measure the looseness near the center of the axle hub.

      Maximum looseness
      0.05 mm (0.00197 in.)

      Note

      Make sure that the dial indicator is set at a right angle to the measurement surface.

      If the looseness is more than the maximum, replace the axle hub.

  6. INSPECT FRONT AXLE HUB RUNOUT


    1. A01XKXG

      Using a dial indicator, measure the runout on the surface of the axle hub outside the hub bolts.

      Maximum runout
      0.08 mm (0.00315 in.)

      Note

      Make sure that the dial indicator is set at a right angle to the measurement surface.

      If the runout is more than the maximum, replace the axle hub.

  7. INSTALL FRONT AXLE HUB GREASE CAP

    Click here

  8. INSTALL FRONT DISC

    Click here

  9. INSTALL DISC BRAKE CYLINDER ASSEMBLY LH

    Click here

  10. INSTALL FRONT WHEEL

    Torque:
    for Aluminum Wheel
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }
    for Steel Wheel
    112 N*m  { 1137 kgf*cm, 82 ft.*lbf }