STEERING KNUCKLE INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL STEERING KNUCKLE LH

    B001H2D

    1. Install the steering knuckle to the front suspension upper arm with the nut.

      Torque:
      110 N*m  { 1122 kgf*cm, 82 ft.*lbf }

    2. Install a new clip.

  2. INSTALL FRONT LOWER BALL JOINT ATTACHMENT LH


    1. Install the front lower ball joint attachment with the 2 bolts.

      Torque:
      160 N*m  { 1632 kgf*cm, 118 ft.*lbf }

  3. CONNECT TIE ROD END SUB-ASSEMBLY LH

    Click here

  4. INSTALL FRONT AXLE HUB SUB-ASSEMBLY LH


    1. Install the front axle hub Click here.

  5. INSTALL FRONT SPEED SENSOR LH

    Click here

  6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  7. INSTALL FRONT WHEEL

    Torque:
    for Aluminum Wheel
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }
    for Steel Wheel
    112 N*m  { 1137 kgf*cm, 82 ft.*lbf }

  8. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT


    1. Inspect and adjust the front wheel alignment Click here.

  9. CHECK SPEED SENSOR SIGNAL


    1. w/ VSC (for Hydraulic Brake Booster):

      Inspect the speed sensor signal Click here.

    2. w/ VSC (for Vacuum Brake Booster):

      Inspect the speed sensor signal Click here.

    3. w/o VSC:

      Inspect the speed sensor signal Click here.