TRANSFER OIL ON-VEHICLE INSPECTION

PROCEDURE


  1. CHECK TRANSFER OIL


    1. A01XJ1Z

      Remove the filler plug and gasket.

    2. A01XC8IE22
      Text in Illustration
      *a 0 to 5 mm

      Check that the oil level is between 0 to 5.0 mm (0 to 0.196 in.) from the bottom lip of the filler plug hole.

      If the result is not as specified, add transfer oil.

      Note

      Too much or too little oil will lead to transfer problems.

    3. When the oil level is too low, check for oil leaks.

    4. Install a new gasket to the filler plug and then tighten the plug.

      Torque:
      37 N*m  { 377 kgf*cm, 27 ft.*lbf }

  2. ADD TRANSFER OIL


    1. Remove the filler plug and gasket.

    2. Add oil so that the oil level is between 0 to 5.0 mm (0 to 0.196 in.) from the bottom lip of the filler plug hole.

      Note


      • Add oil slowly.

      • Add oil a little at a time, waiting several minutes between each addition of oil.

    3. Wait approximately 5 minutes and check that the oil level has not changed.

    4. Install a new gasket to the filler plug and then tighten the plug.

      Torque:
      37 N*m  { 377 kgf*cm, 27 ft.*lbf }