INPUT SHAFT INSPECTION

PROCEDURE


  1. INSPECT NO. 2 SYNCHRONIZER RING


    1. A01XDBF

      Apply gear oil to the cone of the input shaft, and check that the No. 2 synchronizer ring does not turn in either direction while pushing the No. 2 synchronizer ring.


      • If the No. 1 synchronizer ring turns, replace it.

    2. A01XIHJ

      Push the No. 2 synchronizer ring against the cone of the input shaft. Measure the clearance between the No. 2 synchronizer ring and input shaft.

      Standard clearance
      0.70 to 1.70 mm (0.0276 to 0.0669 in.)

      • If the clearance is not as specified, replace the synchronizer ring No. 2 with a new one.