CLUTCH RELEASE CYLINDER(for 1GD-FTV) INSTALLATION

PROCEDURE

1. INSTALL CLUTCH RELEASE CYLINDER ASSEMBLY

   
   

   1. Install the clutch release cylinder with the 2 bolts.

      Torque:

      12 N*m  { 120 kgf*cm, 9 ft.*lbf }

2. CONNECT CLUTCH RELEASE CYLINDER TO FLEXIBLE HOSE TUBE

   
   

   1. Install the tube with the bolt.

      Torque:

      19 N*m  { 194 kgf*cm, 14 ft.*lbf }

   2. Using a union nut wrench, connect the tube to the clutch release cylinder.

      Torque:

      15 N*m  { 155 kgf*cm, 11 ft.*lbf }

      Note

      Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench Click here.

3. INSTALL FRONT PROPELLER SHAFT ASSEMBLY

   
   

   1. Install the front propeller shaft Click here.

4. FILL RESERVOIR WITH BRAKE FLUID

   Click here

5. BLEED CLUTCH LINE

   Click here

6. CHECK FLUID LEVEL IN RESERVOIR

   Click here

7. INSPECT FOR BRAKE FLUID LEAK FROM CLUTCH LINE