SHIFT LEVER INSTALLATION

PROCEDURE


  1. INSTALL TRANSMISSION FLOOR SHIFT ASSEMBLY

    Note

    Check that the park/neutral position switch assembly and the shift lever are in N.


    1. B001FNYE01

      Install the transmission floor shift assembly with the 4 bolts tighten the bolt in the order shown in the illustration.

      Torque:
      14 N*m  { 143 kgf*cm, 10 ft.*lbf }

    2. Connect the 2 connectors.

  2. CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY


    1. Turn the socket of the transmission control cable assembly 180° counterclockwise. While holding the socket in place, push in the lock piece until the lock piece clicks twice.

      B001CNXE02
      Text in Illustration
      *1 Socket *2 Lock Piece
      *a Push in - -

      Note

      Do not over-rotate the socket as it will come off the internal spring and the transmission control cable assembly will not be reusable.

      Tech Tips

      If the lock piece cannot be pushed in, slightly turn the socket clockwise and then push in the lock piece again.

    2. Install the outer part of the transmission control cable assembly to the transmission floor shift assembly retainer. Check that the socket and lock piece are positioned at original position.

      B001HHCE02
      Text in Illustration
      *1 Transmission Floor Shift Assembly Retainer - -
    3. B001HXLE05
      Text in Illustration
      *1 Slider
      *2 Lock Piece

      Slide the slider in the direction shown in the illustration and pull out the lock piece.

    4. B001FWO

      Connect the end of the cable to the shift lever.

      Note


      • The shift lever should be in N.

      • Make sure that the lock piece is pulled up.

      • Push on the end of the cable all the way to the base of the pin.

    5. B001DOH

      Push the lock piece into the adjuster case and lock it.

      Note

      Make sure that the lock piece is completely locked by the slider.

  3. INSPECT SHIFT LEVER POSITION

    Click here

  4. INSTALL CONSOLE BOX ASSEMBLY REAR

    Click here