VALVE BODY ASSEMBLY INSTALLATION

PROCEDURE


  1. INSTALL TRANSMISSION VALVE BODY ASSEMBLY


    1. Install the spring and check ball body.

    2. B001HHOE10
      Text in Illustration
      *1 Pin

      Insert the pin of the manual valve into the hole of the manual valve lever.

    3. B001H6NE09

      Install the transmission valve body with the 19 bolts.

      Torque:
      11 N*m  { 112 kgf*cm, 8 ft.*lbf }

      Tech Tips

      Each bolt length is indicated below.

      32 mm (1.26 in.) for bolt A

      25 mm (0.984 in.) for bolt B

    4. Install the detent spring and detent spring cover with the bolt.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

  2. CONNECT TRANSMISSION WIRE

    Click here

  3. INSTALL VALVE BODY OIL STRAINER ASSEMBLY

    Click here

  4. INSTALL AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY

    Click here

  5. INSTALL REAR NO. 1 ENGINE MOUNTING INSULATOR

    Click here

  6. INSTALL NO. 3 FRAME CROSSMEMBER SUB-ASSEMBLY

    Click here

  7. INSTALL FRONT SUSPENSION MEMBER BRACKET LH AND RH

    Click here

  8. ADD AUTOMATIC TRANSMISSION FLUID


    1. Add automatic transmission fluid Click here.

  9. PERFORM RESET MEMORY

    Perform the RESET MEMORY procedures (A/T initialization) Click here.