TRANSMISSION WIRE INSTALLATION

PROCEDURE

INSTALL TRANSMISSION WIRE
1. Coat a new O-ring with ATF and install it to the transmission wire connector.
2. Install the transmission wire with the bolt.
  
  Torque:
  
  5.4 N*m { 55 kgf*cm, 48 in.*lbf }
3. Connect the transmission wire connector.
  
  Tech Tips
  
  Push up the lever until the claw of the transmission wire connector makes a connection sound.
CONNECT TRANSMISSION WIRE
1. Text in Illustration
  
  *1 Orange
  
  *2 Blue
  
  Connect the 7 connectors to the solenoid valves.
2. Coat the 2 new O-rings with ATF and install them to the 2 ATF temperature sensors.
3. Connect the 2 ATF temperature sensors with the 2 clamps and 2 bolts.
  
  Torque:
  
  for bolt A
  
  10 N*m { 102 kgf*cm, 7 ft.*lbf }
  
  for bolt B
  
  11 N*m { 112 kgf*cm, 8 ft.*lbf }
  
  Tech Tips
  
  Each bolt length is indicated below.
  
  12 mm (0.472 in.) for bolt A
  
  36 mm (1.42 in.) for bolt B
INSTALL VALVE BODY OIL STRAINER ASSEMBLY
1. Coat a new O-ring with ATF and install it to the oil strainer.
2. Install the oil strainer with the 4 bolts.
  
  Torque:
  
  10 N*m { 102 kgf*cm, 7 ft.*lbf }
INSTALL AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY

Note

Remove the gasket and be careful not to spill oil on the contacting surfaces of the transmission case and oil pan.
1. Install a new gasket and the oil pan with the 20 bolts.
  
  Torque:
  
  7.0 N*m { 71 kgf*cm, 62 in.*lbf }
INSTALL REAR NO. 1 ENGINE MOUNTING INSULATOR

Click here
INSTALL NO. 3 FRAME CROSSMEMBER SUB-ASSEMBLY
1. Install the frame crossmember to the engine mounting insulator with the 4 set bolts.
  
  Torque:
  
  30 N*m { 306 kgf*cm, 22 ft.*lbf }
2. Connect the ends of the frame crossmember to the vehicle with the 4 bolts and 4 nuts.
  
  Torque:
  
  72 N*m { 734 kgf*cm, 53 ft.*lbf }
INSTALL FRONT SUSPENSION MEMBER BRACKET LH AND RH

Click here
ADD AUTOMATIC TRANSMISSION FLUID
1. Add automatic transmission fluid Click here.

Text in Illustration
*1	Orange
*2	Blue