AUTOMATIC TRANSMISSION SYSTEM(for 1KD-FTV) L4 Position Switch Circuit

DESCRIPTION

The four wheel drive control ECU judges whether the transfer is in L4 based on the information from the limit switch inside the transfer shift actuator assembly which is detected by the TCM.

The four wheel drive control ECU inputs a signal to the combination meter assembly via CAN communication and turns on the 4LO indicator when the transfer is in L4.

WIRING DIAGRAM

Refer to DTC P2772 Click here.

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (FOUR WHEEL DRIVE CONTROL ECU - BODY GROUND)


    1. B001GZVE02
      Text in Illustration
      *a

      Front view of wire harness connector

      (to Four Wheel Drive Control ECU)

      Disconnect the G53 four wheel drive control ECU connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      G53-21 (L4) - Body ground Always 10 kΩ or higher

    OK

    GO TO TRANSFER SYSTEM Click here

    NG

  2. CHECK HARNESS AND CONNECTOR (FOUR WHEEL DRIVE CONTROL ECU - TCM)


    1. B001FIEE02
      Text in Illustration
      *a

      Rear view of wire harness connector

      (to TCM)

      Disconnect the G71 TCM connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      G71-15 (L4) - Body ground Always 10 kΩ or higher

    OK

    REPLACE TCM Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR