DRIVING SUPPORT ECU INSTALLATION

CAUTION / NOTICE / HINT

Note


  • Do not twist the connectors of the driving support ECU when connecting them.

  • Do not apply more force than necessary to the connectors. If more than 98 N (10 kgf, 22 lbf) of force is applied to a connector, the connector or connector holder may be damaged.

Tech Tips


  • A bolt without a torque specification is shown in the standard bolt chart Click here.

  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. INSTALL DRIVING SUPPORT ECU ASSEMBLY

    A01XGF1

    1. Attach the claw to install the driving support ECU assembly.

      Note

      When a new ECU is installed, perform initialization Click here.

  2. INSTALL ECU INTEGRATION BOX RH

    Click here

  3. INSTALL NO. 2 AIR DUCT SUB-ASSEMBLY

    Click here

  4. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY

    Click here

  5. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    Click here

  6. INSTALL INSTRUMENT PANEL ORNAMENT

    Click here

  7. INSTALL INSTRUMENT SIDE PANEL RH

    Click here

  8. INSTALL COWL SIDE TRIM BOARD RH


    1. Attach the clip and claw to install the cowl side trim board.

    2. Install the clip.

  9. INSTALL DOOR SCUFF PLATE ASSEMBLY RH


    1. Attach the 4 clips, 10 claws and 2 guides to install the door scuff plate.