CRUISE CONTROL MAIN SWITCH INSPECTION

PROCEDURE


  1. INSPECT CRUISE CONTROL MAIN SWITCH ASSEMBLY


    1. w/o Dynamic Radar Cruise Control System:


      1. Measure the resistance according to the value(s) in the table below.

        B001HTBC04
        *a

        Component without harness connected

        (Cruise Control Main Switch)

        		 - -
        Standard Resistance
        Tester Connection Condition Specified Condition
        1 (ECC) - 3 (CCS) Neutral 10 kΩ or higher
        +RES 236 to 244 Ω
        -SET 618 to 642 Ω
        CANCEL 1510 to 1570 Ω
        ON-OFF Switch ON Below 1.5 Ω
        ON-OFF Switch OFF 10 kΩ or higher

        If the result is not as specified, replace the cruise control main switch.

    2. w/ Dynamic Radar Cruise Control System:


      1. Measure the resistance according to the value(s) in the table below.

        B001HCFC04
        *a

        Component without harness connected

        (Cruise Control Main Switch)

        		 - -
        Standard Resistance
        Tester Connection Condition Specified Condition
        1 (ECC) - 3 (CCS) Neutral 10 kΩ or higher
        +RES 236 to 244 Ω
        -SET 618 to 642 Ω
        CANCEL 1510 to 1570 Ω
        ON-OFF Switch ON Below 1.5 Ω
        ON-OFF Switch OFF 10 kΩ or higher

        If the result is not as specified, replace the cruise control main switch.