STARTER(for 2.0 kW Type) INSTALLATION

PROCEDURE


  1. INSTALL STARTER ASSEMBLY


    1. for Automatic Transmission:

      Install the starter assembly with the 2 bolts.

      Torque:
      37 N*m  { 377 kgf*cm, 27 ft.*lbf }

    2. for Manual Transmission:


      1. Temporarily install the starter assembly with bolt.

      2. B001HDWE02
        Text in Illustration
        *1 Clutch Flexible Hose Bracket

        Temporarily install the clutch flexible hose bracket with the bolt.

      3. Tighten the 2 bolts.

        Torque:
        37 N*m  { 377 kgf*cm, 27 ft.*lbf }

    3. Connect the starter connector.

    4. Connect the starter wire harness with the nut.

      Torque:
      9.8 N*m  { 100 kgf*cm, 87 in.*lbf }

    5. Install the terminal cap.

  2. CONNECT CLUTCH RELEASE CYLINDER ASSEMBLY (for Manual Transmission)

    Click here

  3. INSTALL REAR ENGINE UNDER COVER ASSEMBLY

    Click here

  4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.