STARTER(for 2.0 kW Type) REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE FRONT NO. 1 FENDER APRON TO FRAME SEAL LH


    1. Remove the 5 clips and front No. 1 fender apron to frame seal LH.

  4. REMOVE FRONT PROPELLER SHAFT ASSEMBLY

    Click here

  5. REMOVE TRANSMISSION ASSEMBLY (w/ Urea SCR System)


    1. for Manual Transmission:

      Click here

    2. for Automatic Transmission:

      Click here

  6. REMOVE STARTER ASSEMBLY


    1. w/ Urea SCR System:

      Remove the starter assembly.

    2. w/o Urea SCR System:


      1. Open the terminal cap.

      2. B001GV5

        Remove the nut and disconnect the starter wire.

      3. Disconnect the starter connector.

      4. B001FW0

        for Automatic Transmission:

        Remove the 2 bolts, nut and starter assembly.

      5. B001D1B

        for Manual Transmission:

        Remove the 4 bolts, 3 nuts, clip, and then disconnect the clutch release cylinder assembly.

      6. B001CWM

        for Manual Transmission:

        Remove the 2 bolts and starter assembly.