ENGINE IMMOBILISER SYSTEM(w/o Entry and Start System) Security Indicator Light Does not Blink

DESCRIPTION

The transponder key ECU assembly blinks the security indicator light when the immobiliser is set.

WIRING DIAGRAM

B001I08E09

CAUTION / NOTICE / HINT

Note


  • If the transponder key ECU assembly is replaced, refer to the Service Bulletin.

  • When using the GTS with the vehicle ignition switch off, connect the GTS to the vehicle and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the GTS and the vehicle begins. Then select the Model Code "KEY REGIST" under manual mode and enter the following menus: Body Electrical / Immobiliser. While using the GTS, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the GTS and the vehicle.

PROCEDURE


  1. PERFORM ACTIVE TEST USING GTS (SECURITY INDICATOR)


    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / Immobiliser / Active Test.

    5. Perform the Active Test according to the display on the GTS.

      Immobiliser
      Tester Display Test Part Control Range Diagnostic Note
      Security Indicator Security indicator light ON/OFF -
      OK
      Security indicator light can be turned on and off using the GTS.

    OK

    REPLACE TRANSPONDER KEY ECU ASSEMBLY

    NG

  2. CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU ASSEMBLY - SECURITY INDICATOR LIGHT ASSEMBLY AND BODY GROUND)


    1. Disconnect the G74 transponder key ECU assembly connector.

    2. Disconnect the H23 security indicator light assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      G74-8 (IND) - H23-2 (LP) Always Below 1 Ω
      H23-5 (E) - Body ground Always Below 1 Ω
      G74-8 (IND) - Body ground Always 10 kΩ or higher
      H23-2 (LP) - Body ground Always 10 kΩ or higher

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  3. CHECK TRANSPONDER KEY ECU ASSEMBLY (TERMINAL IND)


    1. Connect the G74 transponder key ECU assembly connector.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      H23-2 (LP) - Body ground Key not in ignition key cylinder Pulse generation
      Key in ignition key cylinder Below 1 V

    OK

    REPLACE SECURITY INDICATOR LIGHT ASSEMBLY Click here

    NG

    REPLACE TRANSPONDER KEY ECU ASSEMBLY