THEFT DETERRENT SYSTEM(except 5L-E) PRECAUTION


  1. IGNITION SWITCH EXPRESSION

    Tech Tips

    The type of ignition switch used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are used in this section.

    Expression Ignition Switch (position) Engine Switch (condition)
    Ignition Switch off Off Off
    Ignition Switch ON ON On (IG)
    Ignition Switch ACC ACC On (ACC)
    Engine Start START Start

  2. DOOR CONTROL RECEIVER EXPRESSION


    1. The type of door control receiver used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are used in this section.

      Vehicle Specification Part Name in Manual Actual Part Name
      for 12 Pin Type, with Entry and Start System Door control receiver Electrical key & TPMS receiver assembly
      for 12 Pin Type, without Entry and Start System Door control receiver Door control & tire pressure monitoring system receiver assembly
      for 5 Pin Type, with Entry and Start System Door control receiver Smart Door control receiver
      for 5 Pin Type, without Entry and Start System Door control receiver Door control receiver

  3. KEY EXPRESSION


    1. The type of key used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are used in this section.

      Vehicle Specification Part Name in Manual Actual Part Name
      w/ Entry and Start System Electrical key transmitter sub-assembly Electrical key transmitter sub-assembly
      w/o Entry and Start System Electrical key transmitter sub-assembly Door control transmitter assembly

  4. PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL

    Note


    • After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

      Click here

    • When disconnecting the cable from the negative (-) battery terminal while performing repairs, some systems need to be initialized after the cable is reconnected

      Click here

  5. PRECAUTION WHEN REPLACING THEFT WARNING ULTRASONIC SENSOR


    1. When replacing the theft warning ultrasonic sensor, always replace it with a one having the same part number.