ENTRY AND START SYSTEM(for Start Function) PRECAUTION


  1. PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL

    Note


    • After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

      Click here

    • When disconnecting the cable from the negative (-) battery terminal while performing repairs, some systems need to be initialized after the cable is reconnected.

      Click here

  2. PRECAUTION WHEN USING GTS


    1. When using the GTS with the engine switch off, connect the GTS to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the GTS and the vehicle begins. Then select Model Code "KEY REGIST" under manual mode and enter the following menus: Body Electrical / Entry&Start(CAN). While using the GTS, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the GTS and the vehicle.

  3. PRECAUTION FOR REGISTRATION


    1. If replacing any of the following parts, refer to Service Bulletin.


      1. Certification ECU (smart key ECU assembly)

      2. Steering lock ECU (steering lock actuator or upper bracket assembly)

      3. Electrical key transmitter sub-assembly

      4. ID code box (immobiliser code ECU)

      5. Main body ECU (multiplex network body ECU)

      6. ECM

  4. DOOR CONTROL RECEIVER EXPRESSIONS


    1. The type of door control receiver used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are used in this section.

      Vehicle Specification Part Name in Manual Actual Part Name
      for 12 Pin Type Door control receiver Electrical key & TPMS receiver assembly
      for 5 Pin Type Door control receiver Smart door control receiver assembly