DOOR CONTROL RECEIVER(for 3 Door) REMOVAL

PROCEDURE


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note


    • After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

      Click here

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

      Click here

  2. REMOVE REAR NO. 1 SEAT ASSEMBLY (w/ Rear No. 1 Seat)


    1. for LH Side:

      Remove the rear No. 1 seat assembly.

      Click here

    2. for RH Side:

      Remove the rear No. 1 seat assembly.

      Click here

  3. REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)

    Click here

  4. REMOVE MAT SET PLATE COVER

    Click here

  5. REMOVE REAR FLOOR MAT REAR SUPPORT PLATE

    Click here

  6. REMOVE QUARTER TRIM COVER HOLE LH

    Click here

  7. REMOVE REAR FLOOR CARPET ASSEMBLY

    Click here

  8. REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK

    Click here

  9. REMOVE NO. 1 TONNEAU COVER HOLDER CAP (w/o Tonneau Cover)

    Click here

  10. REMOVE FRONT DECK SIDE TRIM COVER (w/ Tonneau Cover)

    Click here

  11. REMOVE QUARTER TRIM POCKET TRAY

    Click here

  12. REMOVE OUTER LAP BELT ANCHOR COVER

    Click here

  13. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH

    Click here

  14. REMOVE REAR QUARTER TRIM PANEL ASSEMBLY LH

    Click here

  15. REMOVE DOOR CONTROL RECEIVER


    1. B001IJUC01
      *A w/o Tire Pressure Warning System
      *B w/ Tire Pressure Warning System

      Disconnect the connector.

    2. Remove the bolt and door control receiver.