FRONT DOOR LOCK REMOVAL

CAUTION / NOTICE / HINT

PROCEDURE

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

   CAUTION:

   Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

   Note

   
   

   • After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

   • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

2. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH

   Click here

3. REMOVE NO. 2 DOOR INSIDE HANDLE BEZEL LH

   Click here

4. REMOVE ASSIST GRIP COVER LH

   Click here

5. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

   Click here

6. REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP LH

   Click here

7. REMOVE FRONT DOOR SERVICE HOLE COVER LH

   Click here

8. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY LH

   Click here

9. REMOVE FRONT DOOR GLASS RUN LH

   Click here

10. REMOVE FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY LH

    Click here

11. REMOVE FRONT DOOR OUTSIDE HANDLE COVER WITH LOCK CYLINDER ASSEMBLY

    Click here

12. REMOVE FRONT DOOR LOCK ASSEMBLY LH

    
    

    1. Disconnect the connector.

    2. 

       Text in Illustration

       *A	w/o Double Locking System
       *B	w/ Double Locking System
       	Slide

       Using a T30 "TORX" wrench, remove the 3 screws.

    3. Slide the front door lock assembly downward, pull out the front door lock open rod from the outside handle frame, and remove the front door lock assembly and cables as a unit.

    4. Remove the front door lock open rod from the front door lock assembly.

    5. Remove the door lock wiring harness seal from the front door lock assembly.

13. REMOVE FRONT DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY LH

    Click here

14. REMOVE FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY LH

    Click here