TRANSMITTER BATTERY(w/ Entry and Start System) REPLACEMENT

CAUTION / NOTICE / HINT

Note

Take extra care when handling these precision electronic components.

PROCEDURE


  1. REMOVE TRANSMITTER BATTERY


    1. B001FH3C01
      *1 Release Hook Knob

      Slide the release hook knob to remove the mechanical key as shown in the illustration.

    2. B001DQDC01
      B001CE2 Protective Tape

      Using a screwdriver with its tip wrapped in protective tape, pry apart the transmitter housing cover.

      Note

      Do not use excessive force when prying apart the transmitter housing cover.

    3. B001CWHC01
      B001CE2 Protective Tape

      Using a screwdriver with its tip wrapped in protective tape, remove the transmitter battery (lithium battery: CR2032) as shown in the illustration.

      Note


      • Do not push the terminals with your finger.

      • Do not forcibly pry up the transmitter battery as the terminals may be damaged.

      • Do not touch the transmitter battery with wet hands. Moisture may cause rust.

      • Do not touch or move any components inside the transmitter housing case. It may interfere with proper operation.

      • When replacing the transmitter battery, before starting work, remove static electricity that has built up in the body by touching, for example, the vehicle to prevent the electrical key transmitter sub-assembly from being damaged.

  2. INSTALL TRANSMITTER BATTERY


    1. B001G7H

      Install a new transmitter battery (lithium battery: CR2032) with the positive (+) side facing upward, as shown in the illustration.

      Note


      • Do not bend the transmitter battery electrode during installation.

      • Make sure that the positive (+) side and the negative (-) side of the transmitter battery are correctly matched with the transmitter terminals.

      • Keep the inside of the transmitter housing cover free of dust and oil.

      • When replacing the transmitter battery, before starting work, remove static electricity that has built up in the body by touching, for example, the vehicle to prevent the electrical key transmitter sub-assembly from being damaged.

    2. B001E6J

      Install the transmitter housing cover by pressing down on it as shown in the illustration.

    3. B001FG2

      Insert the mechanical key into the transmitter as shown in the illustration.

    4. Press one of the transmitter switches and check that the LED illuminates.

      OK
      Transmitter LED illuminates when a switch is pressed.