REAR DOOR LOCK INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL REAR DOOR INSIDE LOCKING CABLE ASSEMBLY LH

    Click here

  2. INSTALL REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY LH

    Click here

  3. INSTALL REAR DOOR LOCK ASSEMBLY LH

    Note


    • When reusing the removed rear door lock assembly, replace the door lock wiring harness seal on the connector with a new one.

    • Do not allow grease or dust to adhere to the surface of the connector which contacts the door lock wiring harness seal.

    • Reusing the door lock wiring harness seal or using a damaged door lock wiring harness seal may allow water into the connection. This may result in a malfunction of the rear door lock assembly.


    1. B001FTTE02
      Text in Illustration
      *A w/o Double Locking System
      *B w/ Double Locking System
      B001CHY Slide

      Apply MP grease to the sliding parts of the rear door lock assembly.

    2. Install a new door lock wiring harness seal to the rear door lock assembly.

    3. Insert the rear door lock assembly into the rear door outside handle release plate, and set it on the rear door panel.

    4. Check that the rear door outside handle frame release plate is securely connected to the rear door lock assembly.

    5. Using a T30 "TORX" wrench, install the rear door lock assembly with the 3 screws.

      Torque:
      5.0 N*m  { 51 kgf*cm, 44 in.*lbf }

  4. INSTALL REAR DOOR GLASS SUB-ASSEMBLY LH

    Click here

  5. INSTALL REAR DOOR QUARTER WINDOW GLASS LH

    Click here

  6. INSTALL REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY LH

    Click here

  7. INSTALL REAR DOOR GLASS RUN LH

    Click here

  8. INSTALL REAR DOOR SERVICE HOLE COVER LH

    Click here

  9. INSTALL REAR DOOR INNER GLASS WEATHERSTRIP LH

    Click here

  10. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

    Click here

  11. INSTALL ASSIST GRIP COVER LH

    Click here

  12. INSTALL NO. 2 DOOR INSIDE HANDLE BEZEL LH

    Click here

  13. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.