REAR DOOR LOCK REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note


    • After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  2. REMOVE NO. 2 DOOR INSIDE HANDLE BEZEL LH

    Click here

  3. REMOVE ASSIST GRIP COVER LH

    Click here

  4. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

    Click here

  5. REMOVE REAR DOOR INNER GLASS WEATHERSTRIP LH

    Click here

  6. REMOVE REAR DOOR SERVICE HOLE COVER LH

    Click here

  7. REMOVE REAR DOOR GLASS RUN LH

    Click here

  8. REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY LH

    Click here

  9. REMOVE REAR DOOR QUARTER WINDOW GLASS LH

    Click here

  10. REMOVE REAR DOOR GLASS SUB-ASSEMBLY LH

    Click here

  11. REMOVE REAR DOOR LOCK ASSEMBLY LH


    1. B001DOYE01
      Text in Illustration
      *A w/o Double Locking System
      *B w/ Double Locking System
      B001CHY Slide

      Using a T30 "TORX" wrench, remove the 3 screws.

    2. Move the rear door lock assembly downward, pull the release plate out of the rear door outside handle frame, and remove the rear door lock assembly and cables as a unit.

    3. Remove the door lock wiring harness seal from the rear door lock assembly.

  12. REMOVE REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY LH

    Click here

  13. REMOVE REAR DOOR INSIDE LOCKING CABLE ASSEMBLY LH

    Click here