POWER DOOR LOCK CONTROL SYSTEM Collision Door Lock Release Function does not Operate

DESCRIPTION

When an impact is detected, a relay inside the door control battery is operated to switch the power source of the door lock with motor assemblies from the vehicle battery to the door control battery.

WIRING DIAGRAM

B001FV8E01

CAUTION / NOTICE / HINT

Note


  • Inspect the fuses for circuits related to this system before performing the following procedure.

  • As the door control battery is installed between the vehicle battery and main body ECU (multiplex network body ECU), first perform the inspections in How to Proceed with Troubleshooting to confirm that there are no malfunctions in the power source circuit for the main body ECU (multiplex network body ECU) before performing this troubleshooting procedure.

    Click here

  • w/ Entry and Start System:

    If the main body ECU (multiplex network body ECU) is replaced, refer to the Service Bulletin.

PROCEDURE


  1. CHECK DOOR LOCK OPERATION


    1. Check door lock operation.

      Click here

      OK
      All doors lock and unlock normally.
      Result
      Proceed to
      OK
      NG

    NG

    GO TO PROBLEM SYMPTOMS TABLE Click here

    OK

  2. CHECK DOOR CONTROL BATTERY (BATTERY VOLTAGE)


    1. B001CHVC28
      *a

      Front view of wire harness connector

      (to Door Control Battery)

      Disconnect the door control battery connector.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Switch Condition Specified Condition
      A104-8 (IG) - A104-2 (GND1) Ignition switch ON 11 to 14 V
      Result
      Proceed to
      OK
      NG

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  3. CHECK HARNESS AND CONNECTOR (DOOR CONTROL BATTERY - MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU))


    1. Disconnect the A104 door control battery connector.

    2. Disconnect the G216 main body ECU (multiplex network body ECU) connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      A104-9 (ACTG) - G216-3 (ACTG) Always Below 1 Ω
      A104-9 (ACTG) or G216-3 (ACTG) - Other terminals and body ground Always 10 kΩ or higher
      Result
      Proceed to
      OK
      NG

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  4. REPLACE DOOR CONTROL BATTERY


    1. Replace the door control battery with a new or known good one.


      Result
      Proceed to
      NEXT

    NEXT

  5. CHECK DOOR CONTROL BATTERY


    1. Replace the door control battery operation.

      Click here

      OK
      Collision detection door lock function operates normally.
      Result
      Proceed to
      OK
      NG

    OK

    END (DOOR CONTROL BATTERY WAS DEFECTIVE)

    NG

    REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) Click here