POWER DOOR LOCK CONTROL SYSTEM HOW TO PROCEED WITH TROUBLESHOOTING

DTC Code DTC Name
HOW TO PROCEED WITH TROUBLESHOOTING

CAUTION / NOTICE / HINT

Tech Tips


  • Use these procedures to troubleshoot the power door lock control system.

  • *: Use the intelligent tester.

PROCEDURE


  1. VEHICLE BROUGHT TO WORKSHOP

    Result
    Proceed to
    NEXT

    NEXT

  2. INSPECT BATTERY VOLTAGE

    Standard voltage
    11 to 14 V

    If the voltage is below 11 V, recharge or replace the battery before proceeding.

    Result
    Proceed to
    NEXT

    NEXT

  3. CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM* (w/ Speed-sensitive Automatic Door Lock Function)


    1. Using the intelligent tester to check if the CAN communication system is functioning normally.

      Click here

      Result
      Result Proceed to
      CAN DTC is not output A
      CAN DTC is output (for LHD with Entry and Start System) B
      CAN DTC is output (for LHD without Entry and Start System) C
      CAN DTC is output (for RHD with Entry and Start System) D
      CAN DTC is output (for RHD without Entry and Start System) E

    B

    GO TO CAN COMMUNICATION SYSTEM Click here

    C

    GO TO CAN COMMUNICATION SYSTEM Click here

    D

    GO TO CAN COMMUNICATION SYSTEM Click here

    E

    GO TO CAN COMMUNICATION SYSTEM Click here

    A

  4. CHECK COMMUNICATION FUNCTION OF LIN COMMUNICATION SYSTEM*


    1. Check if the LIN communication system is functioning normally.

      Result
      Result Proceed to
      LIN DTC is not output A
      LIN DTC is output B

    B

    GO TO LIN COMMUNICATION SYSTEM Click here

    A

  5. CHECK FOR DTC* (w/ Speed-sensitive Automatic Door Lock Function)


    1. Check for DTCs.

      Click here

    2. Recheck for DTCs.

      Result
      Result Proceed to
      DTC is not output A
      DTC is output B

    B

    GO TO DIAGNOSTIC TROUBLE CODE CHART Click here

    A

  6. PROBLEM SYMPTOMS TABLE


    1. Refer to Problem Symptoms Table.

      Click here

      Result
      Result Proceed to
      Fault is not listed in problem symptoms table A
      Fault is listed in problem symptoms table B

    B

    ADJUST, REPAIR OR REPLACE IN ACCORDANCE WITH PROBLEM SYMPTOMS TABLE

    A

  7. OVERALL ANALYSIS AND TROUBLESHOOTING


    1. Operation Check.

      Click here

    2. Terminals of ECU.

      Click here

    3. Data List / Active Test.

      Click here

      Result
      Proceed to
      NEXT

    NEXT

  8. REPAIR OR REPLACE

    Result
    Proceed to
    NEXT

    NEXT

  9. CONFIRMATION TEST

    Result
    Proceed to
    NEXT

    NEXT

    END