NETWORK GATEWAY ECU INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • A bolt without a torque specification is shown in the standard bolt chart Click here.

  • Use the same procedure for LHD and RHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. INSTALL NETWORK GATEWAY ECU


    1. Attach the 2 claws to install the network gateway ECU to the ECU integration box RH.

  2. INSTALL ECU INTEGRATION BOX RH


    1. Install the ECU integration box RH with the 2 nuts and bolt.

    2. Attach the harness clamp.

    3. Connect the connectors.

      Note


      • Do not twist the connectors of ECU when connecting them.

      • Do not apply more force than necessary to the connectors. If more than 98 N (10 kgf, 22 lbf) of force is applied to a connector, the connector or connector holder may be damaged.

  3. INSTALL NO. 2 AIR DUCT SUB-ASSEMBLY

    Click here

  4. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY

    Click here

  5. INSTALL INSTRUMENT PANEL ORNAMENT

    Click here

  6. INSTALL INSTRUMENT SIDE PANEL RH

    Click here

  7. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    Click here

  8. INSTALL COWL SIDE TRIM BOARD RH

    Tech Tips

    Use the same procedure described for the LH side.

    for 5 Door: Click here

    for 3 Door: Click here

  9. INSTALL DOOR SCUFF PLATE ASSEMBLY RH

    Tech Tips

    Use the same procedure described for the LH side.

    for 5 Door: Click here

    for 3 Door: Click here

  10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.