METER / GAUGE SYSTEM OPERATION CHECK

CHECK INDICATOR/WARNING LIGHT

1. Check the following indicators and warning lights.

   Indicator/Warning Light	Switch Condition	Specified Condition
   Brake warning light	Ignition switch off → ON	Comes on for 3 seconds
   ABS warning light
   SLIP indicator light
   TRC OFF indicator light
   VSC OFF indicator light
   CRAWL indicator light
   Downhill assist control indicator light
   KDSS indicator light
   Eco driving indicator Light
   Oil maintenance warning light
   OIL level indicator light
   T-BELT indicator light
   SEDIMENTER/FUEL FILTER indicator light
   SEDIMENTER indicator light
   SPEED LIMIT indicator light
   PCS indicator light
   PPS warning light
   Master warning light
   BSM indicator light
   Headlight beam level control system warning light
   LED headlight warning light
   Tire pressure warning light
   Diesel particulate filter warning light
   SRS warning light	Ignition switch off → ON	Comes on for 6 seconds
   CHARGE warning light	Ignition switch off → ON	Illuminates when ignition switch turned to ON Turns off when engine started
   OIL PRESSURE warning light
   A/T OIL TEMP warning light
   MIL
   SIL indicator light

CHECK SPEEDOMETER

1. Connect the GTS to the DLC3.

2. Turn the ignition switch to ON.

3. Turn the GTS on.

4. Enter the following menus: Powertrain / Engine and ECT / Data List.

   If the result is not as specified, the speedometer may have a malfunction.

   Note

   Do not use worn, underinflated or overinflated tires as the speedometer reading will be inaccurate.

   Check the deflection width of the speedometer indicator.

   CHECK TACHOMETER

   
   

   1. Connect a tune-up tachometer and start the engine.

   2. Compare the test results with the tachometer indicator.

   
   

   • *: for Gasoline Engine

   If the result is not as specified, the tachometer may have a malfunction.

   CHECK METER/GAUGE

   
   

   1. Connect the GTS to the DLC3.

   2. Perform the Active Test Click here.

   CHECK WARNING/INDICATOR LIGHT

   
   

   1. Connect the GTS to the DLC3.

   2. Perform the Active Test Click here.

   CHECK MULTI-INFORMATION DISPLAY (for Segment Display Type [except 5L-E])

   
   

   1. Connect the GTS to the DLC3.

   2. Perform the Active Test Click here.

   CHECK MULTI-INFORMATION DISPLAY (for TFT Display Type)

   
   

   1. Connect the GTS to the DLC3.

   2. Perform the Active Test Click here.