REAR CRANKSHAFT OIL SEAL INSTALLATION

PROCEDURE


  1. INSTALL ENGINE REAR OIL SEAL


    1. Apply MP grease to the lip of a new rear engine oil seal.

      Note


      • Keep the lip free of foreign matter.

      • Do not allow MP grease to contact the dust seal.

    2. B001GFNE02
      Text in Illustration
      *1 Rear Oil Seal Retainer
      *2 Rear Engine Oil Seal
      *a 0 to 1.0 mm (0 to 0.0394 in.)

      Using SST and a hammer, tap in the rear engine oil seal to the rear engine oil seal retainer edge.

      SST
      09351-40010   ( 09351-04010, 09351-04020 )

      Note


      • The acceptable depth from the top of the rear engine oil seal retainer is 0 to 1.0 mm (0 to 0.0394 in.)

      • Keep the lip free from foreign matter.

      • Do not tap the rear engine oil seal at an angle.

      • Make sure that the rear engine oil seal is properly installed.

  2. INSTALL REAR END PLATE

    Click here

  3. INSTALL FLYWHEEL SUB-ASSEMBLY

    Click here

  4. INSTALL CLUTCH DISC ASSEMBLY (for Manual Transmission)

    Click here

  5. INSTALL CLUTCH COVER ASSEMBLY (for Manual Transmission)

    Click here

  6. INSPECT AND ADJUST CLUTCH COVER ASSEMBLY (for Manual Transmission)

    Click here

  7. INSTALL AUTOMATIC TRANSMISSION ASSEMBLY (for Automatic Transmission)

    Click here

  8. INSTALL MANUAL TRANSMISSION UNIT ASSEMBLY (for Manual Transmission)

    Click here