DRIVE BELT INSTALLATION

PROCEDURE


  1. INSTALL FAN AND GENERATOR V BELT


    1. Set the fan and generator V belt onto each part.

      Tech Tips

      When installing the fan and generator V belt, attach the fan and generator V belt to the No. 1 idler pulley sub-assembly last.

    2. While turning the V-ribbed belt tensioner assembly clockwise, remove the pin.

    3. Check that the fan and generator V belt fits properly in the ribbed grooves.

      Note

      Make sure that the fan and generator V belt is set properly on each pulley.

  2. INSTALL VISCOUS HEATER V BELT (w/ Viscous Heater)


    1. Install the viscous heater V belt.

    2. A01XD64

      Turn the bolt and adjust the tension of the viscous heater V belt.

    3. A01XKFY

      Tighten the 2 bolts.

      Torque:
      39 N*m  { 398 kgf*cm, 29 ft.*lbf }

    4. Check the tension of the viscous heater V belt Click here.

  3. INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY (w/ Viscous Heater)

    Click here