REAR CRANKSHAFT OIL SEAL INSTALLATION

PROCEDURE

1. INSTALL REAR CRANKSHAFT OIL SEAL

   
   

   1. Apply MP grease to the lip of a new rear crankshaft oil seal.

   2. 

      Using SST and a hammer, tap in the oil seal until its surface is flush with the rear oil seal retainer edge.

      SST

      09518-36030

      09950-70010   ( 09951-07200 )

      Note

      
      

      • The acceptable depth from the top of the oil seal retainer is 0 to 0.8mm (0 to 0.315 in.)

      
      

      • Keep the lip free from foreign matter.

      
      

      • Do not tap the oil seal at an angle.

      
      

      • Make sure that the oil seal is properly installed.

2. INSTALL REAR END PLATE

   Click here

3. INSTALL FLYWHEEL SUB-ASSEMBLY (for Manual Transmission)

   Click here

4. INSTALL PUMP IMPELLER DRIVE PLATE (for Automatic Transmission)

   Click here

5. INSTALL CLUTCH DISC ASSEMBLY (for Manual Transmission)

   Click here

6. INSTALL CLUTCH COVER ASSEMBLY (for Manual Transmission)

   Click here

7. INSPECT AND ADJUST CLUTCH COVER ASSEMBLY (for Manual Transmission)

   Click here

8. INSTALL MANUAL TRANSMISSION ASSEMBLY (for Manual Transmission)

   
   

   1. Install the manual transmission Click here.

9. INSTALL AUTOMATIC TRANSMISSION ASSEMBLY (for Automatic Transmission)

   
   

   1. Install the automatic transmission Click here.