DRIVE BELT INSTALLATION

PROCEDURE


  1. INSTALL FAN AND GENERATOR V BELT


    1. A01XEXHE01
      Text in Illustration
      *1 Vane Pump
      *2 Water Pump
      *3 No. 2 Idler
      *4 Generator
      *5 Cooler Compressor or Idler Pulley
      *6 No. 1 Idler
      *7 Crankshaft
      *8 V-ribbed Belt Tensioner

      Set the V belt onto every part.

    2. While turning the belt tensioner counterclockwise, remove the pin.

      Note

      Make sure that the V belt is properly installed to each pulley.

    3. Check that the belt fits properly in the ribbed grooves.

      Tech Tips

      Make sure to check by hand that the belt has not slipped out of the grooves on the bottom of the pulley.