HEATED OXYGEN SENSOR INSTALLATION

PROCEDURE


  1. INSTALL HEATED OXYGEN SENSOR


    1. A01XES8E02
      Text in Illustration
      *a Fulcrum Length

      Using SST, install the heated oxygen sensor.

      SST
      09224-00011
      Torque:
      Specified tightening torque
      44 N*m  { 449 kgf*cm, 32 ft.*lbf }

      Tech Tips


      • Make sure SST and the wrench are connected in a straight line.

      • Calculate the torque wrench reading when changing the fulcrum length of the torque wrench Click here.

      • When using SST (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 180 mm (7.09 in.)): 38 N*m (384 kgf*cm, 28 ft.*lbf)

    2. Attach the wire harness clamp.

    3. Connect the heated oxygen sensor connector.